Digi TransPort WR11 - At&Z: Store Phone Number

Using the command-line interface AT commands
Digi TransPort® Routers User Guide
164
at&z: Store phone number
The at&z command stores “default” telephone numbers within the router that may subsequently
dialed when DTR dialing is enabled or by using the S= modifier in the ATD dial command. You can store
one telephone number for each ASY port. For example, to store the phone number 0800 123456 as
the default number to be associated with ASY 2, enter:
at &z2=0800123456
If the number of the ASY port is not specified, the number is stored according to the port from which
the command was entered. For example, entering this command from ASY 3:
at &z=0800123456
Has the same effect as this command being entered from any port:
at &z3=0800123456
Once a number is stored, you can dial it from the command line using the atd command with the S=
modifier:
at ds=3
This means that you can dial any stored number from any port. If DTR dialing has been is enabled by
setting S33=1 for the port, the number associated with that port is dialed when the DTR signal for
that port changes from Off to On. This is because you can use DTR dialing with the number associated
with the port to which the terminal is connected only.