Hardware features TransPort WR44 RR hardware features
Digi TransPort® Routers User Guide
92
1. Primary cellular (WWAN) antenna connector: A TNC female connector that connects the
router’s primary cellular antenna.
2. Primary Wi-Fi (WLAN) antenna connector (Wi-Fi models only): A TNC male connector that
connects the router’s secondary Wi-Fi antenna.
3. GPS antenna connector (GPS models only): A TNC male connector that connects the
router’s GPS antenna.
4. Secondary cellular (WWAN) antenna connector: A TNC female connector that connects the
router’s secondary cellular antenna. It is highly recommended to use the secondary antenna
for diversity. In most circumstances, dual antennas will provide improved signal strength thus
better performance.
5. Secondary Wi-Fi (WLAN) antenna connector (Wi-Fi models only): A TNC male connector
that connects the router’s secondary Wi-Fi antenna.
6. 9-36VDC socket: An M12 socket that connects the router to an alternative 9-36VDC power
supply (not supplied) using the supplied fused power cable. This cable also contains two
programmable GPIO signal lines.
7. Serial port: This M12 port provides an asynchronous RS232 serial port for connecting the
router to a compatible serial device. This is a DCE serial port and allows CLI access to the
device by default; the baud rate is 115200.
8. LAN ports: These M12 ports connect the router to a 10/100 base-T LAN. These ports are auto-
sensing for speed and wiring (straight-through or cross-over).
Enclosure features
1. Rugged Enclosure
2. Mounting Tabs
To Next Page
Loading...
