Digi TransPort WR11 - Set Web and Command Line Interface Options

Configuring system settings Set web and command line interface options
Digi TransPort® Routers User Guide
722
Set web and command line interface options
É Web
1. Go to Configuration > System > General > Web /Command Line Interface.
2. Set web and command line options as needed:
Automatically log user out if idle for h hours m minutes s seconds
To limit the probability of unauthorized users gaining access to the router, login timeouts are
applied. These timeouts cause an existing connection to be closed after a predefined period.
The default is 20 minutes.
For users connected on the local Async port
Use access level None, Low, Med, High, Super
For security purposes, logging into the router is controlled by a user access level. This
parameter controls the access level that applies when logging in via the local asynchronous
serial port.
Automatically log user out Never / If idle for h hrs m mins s secs
How long the local port allows access before terminating the connection and requiring the user
to log in again. Selecting the Never buttons allows permanent access to the router via the local
asynchronous serial port. If, for security reasons, it is required that the access should be
limited, the appropriate time period can be entered into the text entry boxes.
Disable Remote command echo for Telnet sessions
Enables/disables command echo for remote access. This applies to Telnet and TRANSIP
sessions.