Digi TransPort WR11 - Configure CUD Mappings Parameters

Configuring legacy protocols Configure Protocol Switch software
Digi TransPort® Routers User Guide
673
Configure CUD mappings parameters
Protocol Switch CUD mappings allow you to map an incoming call’s CUD (call user data) from one
value to another. The PID (protocol identifier) portion of the CUD, if present, is maintained from input
to output and is not involved in the comparison.
ÉWeb
1. Go to Configuration > Network > Protocol Switch > CUD Mappings.
2. Enter CUDmappings. The CUDMappings page displays a table with four columns in which you
can specify the CUD In values, corresponding CUD Out values and to which interfaces the
mappings should be applied. The interface field defines which output interfaces this mapping
applies to. Wildcard characters are allowed, and In each case the interface type to which the
mapping applies can be selected from ANY, LAPD, LAPB0, LAPB1, LAPB2, or XOT.
3. Click Add to add each CUDmapping.
4. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
cudmap
0-9
cudfrom 0-65536 CUD In
cudmap
0-9
cudto 0-65536 CUD Out
cudmap
0-9
Interface 0, 1, 2, 3, 4, 12
0=Any
1=LAPD
2=LAPB 0
3=LAPB 1
4=XOT
12=LAPB 2
Interface