Digi TransPort WR11 - Configure Advanced Remote Management Settings

Configuring remote management Use Digi Remote Manager to manage devices
Digi TransPort® Routers User Guide
740
Configure advanced remote management settings
The main group of Remote Manager settings, along with the system defaults, are sufficient to
establish a connection to the Remote Manager server. The settings in the Advanced section allow you
to fine-tune the Remote Manager connection.
Advanced remote management settings control detecting loss of connection. When the router first
connects to the Remote Manager server, the link parameters are sent to it. The WAN settings and
Ethernet settings described below are identical, but it should be noted in the command line
descriptions, the default keepalive intervals are different. This is owing to the different characteristics
of PPP and Ethernet links.
ÉWeb
1. Go to Configuration > Remote Management >Remote Manager > Advanced.
2. Configure the Connection Settings, as needed.
Connect using a proxy
The router connects using HTTPover proxy.
Proxy Port
When Connect using a proxy is selected, this value is the proxy host port.
Proxy URL
When Connect using a proxy is selected, this value is the URLof the proxy server to which
the router connects.
Disconnect when Remote Manager is idle
Once the router has connected to the Remote Manager server, and the server has established
that all the settings it holds for the router are current, and no new changes are being
requested, the traffic between the router and Remote Manager server reduces to the sending
of keep-alive packets. In this situation, it may be advantageous to terminate the connection to
reduce bandwidth or to keep data costs down. Enabling this setting causes the router to
negotiate termination of the connection.
Idle Timeout h hours, m minutes, s seconds
The timeout entered here defines how long the router should wait after detecting the idle
condition before negotiating termination of the link. Default is 10 seconds.
Data Service Token / Confirm data service token
3. Configure the WAN Settings, as needed.
Receive Interval s seconds
The time between keep-alive packets that the router should wait before considering that the
connection may be lost.
Transmit Interval s seconds
The interval between transmission of keep-alive packets.