Performing device administration tasks Manage files
Digi TransPort® Routers User Guide
918
Create a universal config.da0 file using tags
The config.da0 contains a list of commands, one per line that are parsed at boot. The commands in
this file differ, depending on the model of the router, the firmware in use and the hardware options
installed.
You can create a single universal configuration file using tags, defining sections that only relate to a
specific hardware type or firmware version.
The tag values you can use are:
n The base model, for example: DR6410
n The complete model, for example: DR6410-H0A
n The platform build string, for example: 8W
n The type of DSL, for example: DSL2, 2+
n The type of WWAN module detected, for example: E (Edge), C (CDMA)
n The complete WWAN module string, for example: MOTO_G24SIEMENS_GPRS, SIEMENS_MC75,
NOVATEL_3G, SIERRA_3G, OPTION_3G, NOVATEL_CDMA, CMOTECH_CDMA, SIERRA_CDMA
n PSTN or ISDN module, for example: PSTN, ISDN
Enclose the tags within angle brackets. Open and close the configuration sections with the relevant
tag. For example, to open: <DR6410>
To close: </DR6410>
Note use of the / in the closing tag.
To view a list of defined tags on a router, use the command tags. Here is example output of the tags
command:
Rout er >t ags
t ags def i ned: . .
Tr ansPor t
DR64
dr 6410
8W
OPTI ON_3G
I SDN
DSL
61690
OK
Example scenario
Suppose a single configuration file is required for a range of DR6410 routers. There is a mix of three
types of 3G WWAN modules and some have GPRS modules installed. Different W-WAN modules need
different modemcc commands to correctly configure the ASY ports. All these modules can have their
own specific commands in one config file.
To Next Page
Loading...
Need help?
General
