Digi TransPort WR11 - Set Miscellaneous System Options

Configuring system settings Set miscellaneous system options
Digi TransPort® Routers User Guide
725
Set miscellaneous system options
É Web
1. Go to Configuration > System > General.
Depending on the router model, this page may have several miscellaneous system options in
the Miscellaneous section; for example:
2. Set miscellaneous options as needed:
Use Config n when the router powers up
The router maintains two configuration files, either of which may be invoked on power-up.
Select the required one from the drop-down selection box. Use this option with care as
selecting the incorrect configuration file can cause confusion.
Allow anonymous FTP login
Enables or disables the router to accept anonymous logins. The default state is Off and the
security implications of enabling this option should be considered carefully before applying.
Additional FTP NAT port n
Standard FTP uses two well-known ports, a control port and data port. These are low-number
ports, and can be blocked by firewall rules. As such, it may be that an FTP server may be
listening on a non-standard control port. This parameter sets the port the router should
monitor for FTP PORT and PASV commands. These commands contain information relating to
IP addresses and ports that should be modified during the NAT process. The NAT modifications
can result in different-sized packets being generated that then require that the TCP sequence
numbers be modified to allow for the changes.
SNMP Enterprise number
The value of the OID (Object IDentifier) SNMP management tools to use when accessing the
MIB (Management Information Block). This number must form part of the OID for accessing
individual items in the MIB as a prefix. For example: SNMPv2-SMI::enterprises.16378.10001.