Digi TransPort WR11 - Configure SNMP Settings

Configuring remote management Use SNMP for remote management
Digi TransPort® Routers User Guide
744
Configure SNMP settings
ÉWeb
1. Go to Configuration > Remote Management > SNMP.
2. Configure the SNMP settings, as needed.
Enable SNMPv1
Enables/disables support for version 1 of the protocol.
Enable SNMPv2c
Enables/disables support for version 2c of the protocol.
Enable SNMPv3
Enables/disables support for version 3 of the protocol.
Use TACACS+ if enabled for authorisation
If enabled, the router uses TACACS to authenticate user requests, if TACACS+ is properly
configured. See Use TACACS+ to control access to the router.
Use UDP Port n
The UDP port number to use. The default is UDP port 161.
SNMPv3 Engine ID
Required as part of the SNMP v3 protocol. This is a 24-hexadecimal character string; any
trailing zeros in this string making the value up to 24 characters can be omitted. A remote
engine ID is required when a SNMP v3 Inform is configured. The router uses the remote engine
ID to compute the security digest for authenticating and encrypting packets sent to a user on
the remote host.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
snmp 0 v1enable on, off Enable SNMPv1
snmp 0 v2cenable on, off Enable SNMPv2c
snmp 0 v3enable on, off Enable SNMPv3
snmp 0 engineid String SNMPv3 Engine ID
snmp 0 port 0-65535 Use UDP Port
Default=161
snmp 0 tacacs_auth on, off Use TACACS+ if enabled for authorisation