Configuring IP routing and forwarding Configure static routes
Digi TransPort® Routers User Guide
437
Only queue one packet while waiting for the interface to connect
When enabled, the router enqueues only one packet while waiting for the interface to connect. When
unchecked, the router will enqueue two packets.
When this route becomes available, deactivate the following interfaces x,y x,y
The interfaces specified by the values in these two pairs of drop-down list and text boxes are
deactivated when this route becomes available again after being out of service. The router typically
uses this feature to deactivate backup interfaces when the primary interface becomes available after
being out of service. Select the required interface from the drop-down list and enter the interface
instance number into the text box as usual.
When this route becomes unavailable, remove the “Out of Service” state on x,y
The interface and instance that should be taken out of the Out of Service state when the interface
that this route is configured to use is deactivated. Available interface options are None, PPP,
Ethernet, and Tunnel)
Keep this route in service for s seconds after OOS state is cleared
When enabled, the following text box is enabled (such as it is no longer disabled), allowing a value to
be entered. The value specifies the period that the interface specified above will remain in service
even though it is actually unable to pass traffic immediately. This is behavior useful in situations where
a PPP interface is activating and traffic should not try the next interface until this one has been
allowed a certain amount of time to come up. When this timer expires, if the interface is unable to
pass traffic, it will be marked Out of Service and the next interface will be tried.
Assign this route to recovery group n
Assigns the route to a recovery group. This means that if all the routes in a particular recovery group
go out of service, the out of service status is cleared for all routes in that group. If one route in a group
comes back into service, all routes with a lower priority (metric) also have their out of service status
cleared.
Related CLI commands
Command line
Command Instance Parameter Values
Equivalent
web
parameter
route n metric 0-2147483647 Use metric n
when the
interface is not
active
route n srcip Valid IP address a.b.c.d IP Address
a.b.c.d
To Next Page
Loading...
