Digi TransPort WR11 - Configure Ethernet Quality of Service (Qos) Parameters

Configuring network interfaces Configure Ethernet interfaces
Digi TransPort® Routers User Guide
192
Configure Ethernet Quality of Service (QoS) parameters
ÉWeb
1. Go to Configuration > Network > Interfaces >Ethernet>ETH n > QoS.
The parameters on the QoS page control the Quality of Service management facility. Each
Ethernet interface has an associated QoS instance, where ETH 0 maps to QoS 5, ETH 1 maps to
QoS 6 and so on. These QoS instances include ten QoS queues into which packets may be
placed when using QoS. Each of these queues must be assigned a queue profile from the
twelve available.
2. Enter the QoS parameters as needed:
Enable QoS on this interface
When enabled, displays the following QoS configuration parameters:-
Link speed n Kbps
Set this setting to the maximum data rate that this PPP link is capable of sustaining. The
router uses this setting when calculating whether or not the data rate from a queue can
exceed its minimum Kbps setting, as determined by the profile assigned to it and send at a
higher rate (up to the maximum Kbps setting).
Queue n
Below this column heading is a list of ten queue instances. Each instance is associated with the
profile and priority on the same row.