Digi TransPort WR11 - Set Commands to Run Automatically at Bootup

Configuring system settings Set commands to run automatically at bootup
Digi TransPort® Routers User Guide
721
Set commands to run automatically at bootup
The router can be configured to run a number of commands once it has booted. These commands are
associated with specific asynchronous serial interfaces. For example, suppose a Script Basic script,
sample.bas, must be run at boot up. Autorun commands are normally associated with an ASY port,
but running a script for example is not ASY port-specific.
É Web
1. Go to Configuration >System General > Autorun Commands.
2. In the Command field, enter the CLI command to run at bootup. For example, to run the Script
Basic script sample.bas at bootup, you would enter bas sample.bas.
3. Click Add.
4. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
cmd n autocmd Valid CLI command Autorun Commands