Digi TransPort WR11 - Templog Command: Monitor Router Temperature

Using the command-line interface Application commands
Digi TransPort® Routers User Guide
150
templog command: monitor router temperature
The on-board temperature sensors are sampled every 60 seconds. Any interesting changes in the
temperature are logged to a special flash file, templog.c1. Use templog 0 status to view the last
stored record in this file.
There are two temperature sensors built in: one on the motherboard and one on the modem module.
If a temperature is reached that is outside of normal operating limits, an event will be logged in the
eventlog.txt file.