Digi TransPort WR11 - Use Special Usernames in Commands

Using the command-line interface Application commands
Digi TransPort® Routers User Guide
133
r _comp: OFF
r _addr : OFF
r _cal l b: 0
r xt i meout : 23
r doosdl y: 0
r est del : 2000
r eboot f ai l s: 0
r i p: 0
r i pi p:
r i paut h: 1
r i pi s: OFF
r _md5: 1
r _ms1: 1
r _ms2: 1
r bcast : OFF
OK
Use special usernames in commands
You can use several special usernames for local and remote authentication:
Username Description
%s Uses the serial number of the router as the username.
%i Uses the IMEI of the cellular module as the username.
%c Uses the ICCID of the SIM as the username.
If a % symbol is part of the username, you must enter another % symbol as an escape character. For
example, enter user%1 as user%%1.