Digi TransPort WR11 - Configure NUI Mappings

Configuring legacy protocols Configure X.25 parameters
Digi TransPort® Routers User Guide
621
Configure NUI mappings
When a TPAD call is taking place, the attached terminal sometimes only specifies a NUI (Network User
ID) to call. If the X.25 network requires an NUA instead of an NUI to determine the destination of a
call, you can use the NUI Mappings table to convert an NUI to an NUA. If a TPAD call specifies a call in
which the NUI matches an entry the call actually placed on the network will contain the respective
NUA and no NUI.
ÉWeb
1. Go to Configuration > Network > Legacy Protocol > X.25 > NUI Mappings.
2. Enter the NUImappings.
3. Click Apply.
Command line
Command Instance Parameter Values
Equivalent web
parameter
nuimap n nua text Maps to NUA
nuimap n nui text NUI