Digi TransPort WR11 - Configure Sending and Receiving SMS Messages

Configuring network interfaces Configure mobile (cellular) interfaces
Digi TransPort® Routers User Guide
242
Configure sending and receiving SMS messages
You can configure the mobile routers to send and receive SMS messages. The sending of SMS
messages could for example be in conjunction with sending alarms and received messages for
configuration changes, or status requests.
Note SMS messaging is supported in some, but not all, cellular modules in Digi TransPort routers.
ÉWeb
1. Go to Configuration - Network > Interfaces > Mobile > SMSSettings.
2. Enter the SMS settings:
Poll for incoming SMS messages
When enabled, displays the following parameter:-
Every n minutes
The interval, in minutes, that the router will wait in between checks for incoming SMS
messages. Setting this interval to 0 turns off checking.
Send received SMS messages to the command interpreter
If enabled, any received SMS messages are sent to the command interpreter.
Enable command replies via SMS
Enables or disables replies to SMS commands.