Configuring security Use a RADIUS client for authentication
Digi TransPort® Routers User Guide
804
Configure advanced RADIUS client parameters
ÉWeb
1. Go to Configuration > Security> Radius> Radius Client n> Advanced.
Enter advanced settings as needed:
Use Source IP Address
If required, select an alternative source interface and instance. Select the required interface
from the drop-down list and enter the interface instance in the text box. Interface options are
n Auto
n PPP
n Ethernet
If there is no response from the server
Retransmit the request after s seconds
The interval between retransmissions of RADIUS packets.
Stop the negotiation after n retransmissions
The maximum number of times RADIUS data should be transmitted to the NAS before the
negotiation is deemed to have failed.
Stop the negotiation if there is no activity for s seconds
The inactivity period after which the negotiation procedure is considered a failure.
2. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
radcli 0 ip_ent Blank,ETH,PPP
Blank=Auto
Use Source IP Address
radcli 0, 1 retranint 0-2147483647
Default 5
Retransmit the request after s seconds
radcli 0, 1 retran 0-2147483647
Default 3
Stop the negotiation after n retransmissions
radcli 0, 1 inactto 0-2147483647
Default 30
Stop the negotiation if there is no activity for s
seconds
To Next Page
Loading...
