Digi TransPort WR11 - Cross Virtual Routing Entry; Process for Configuring Vrfs

Configuring IP routing and forwarding Configure Virtual Routing and Forwarding (VRF)
Digi TransPort® Routers User Guide
465
Attribute
name Attribute description Scheme
Polling
interval
Virtual
Routing
Entries
Array of Cross Virtual Routing Entry objects sharing a
single destination
IPCore Configuration
Configuration Virtual Routing Entity (VRF) name IPCore Configuration
Cross virtual routing entry
Attribute
name Attribute description Scheme
Polling
interval
Outgoing
Virtual
Routing
Entity
Identifier
Outgoing virtual routing entity Object Identifier (OID) IPCore Configuration
Incoming
and
Outgoing
Virtual
Routing
Tags
Incoming and outgoing virtual routing tags IPCore Configuration
Destination
IP Subnet
Final destination IP subnet IPCore Configuration
Next Hop
IP Address
Type
List of the address families (IPv4, IPv6, or both) IPCore Configuration
Type Route entry type (Null, Other, Invalid, Direct, Indirect, Static) IPCore Configuration
Routing
Protocol
Type
Routing protocol type (Null, Other, Local, Network Managed,
ICMP, EGP, GGP, Hello, RIP, IS-IS, ES-IS, Cisco IGRP, BBN, SPF
IGP, OSPF, BGP, EIGRP)
IPCore Configuration
Outgoing
Interface
Name
Address resolution entity (ARP entity) IPCore Configuration
Process for configuring VRFs
To configure one or more VRFs, perform these steps:
Step Command Purpose
1 Switch# configure terminal Enters global configuration
mode.