Digi TransPort WR11 - Capture Data Traffic

Managing networks and connections Analyze data traffic
Digi TransPort® Routers User Guide
886
Capture data traffic
ÉWeb
1. Go to Management > Analyser >Settings.
2. Configure the Analyser to capture data traffic:
Enable Analyser
Enables or disables the Analyser.
Maximum packet capture size
The number of bytes that are captured and stored for each packet. If the packet is bigger than
the configured size, the packet is truncated. Bear in mind that the larger this value, the quicker
the pseudo file ana.txt will become full so that the effective length of the Analyser trace is
reduced.
Log Size
The maximum size of the pseudo file ana.txt for storing the captured data packets. Once the
maximum size is reached, the oldest captured data packets are overwritten when new
packets are captured. The maximum value is 180 Kb, but since the data is compressed, more
than 180 Kb of trace data will be captured.
Protocol layers
The check-boxes under this heading specify which protocol layers are captured and included in
the Analyser trace. You can choose to capture Layer 1 (physical / PPP), Layer 2 (Layer protocol,
the Network Layer (Layer 3) protocol or any combination, by checking or clearing the
appropriate check-boxes. In addition, you may select XOT (X.25 over TCP/IP) tracing if this
feature is included on the router.
Enable IKE debug
Enables or disables including IKE packets in the Analyser trace when using IPsec.
Enable QMI trace
Enables or disables including data from the Qualcomm Management Interface in the Analyser
trace.
Enable SNAIP trace
Enables or disables including the SNAIP packet in the Analyser trace.
ISDN Sources
Selects the ISDN channels (D, B1 and B2) over which packets will be captured and included in
the Analyser trace.
LAPB Links
Selects the LAPB links over which packets are captured and included in the Analyser trace.