Digi TransPort WR11 - Configure Advanced Dialserv Parameters

Configuring network interfaces Configure DialServ interfaces
Digi TransPort® Routers User Guide
307
Configure advanced DialServ parameters
ÉWeb
1. Go to Configuration > Network >Interfaces > DialServ > Advanced.
2. Configure advanced DialServ parameters as needed:
Metric
The route metric that should be applied to this interface.
Enable “Always On” mode of this interface
When enabled, the following two options are displayed:
On/On and return to service immediately
Select whether the always-on functionality should simply be enabled or whether the additional
facility to return the interface to the In Service state should be applied.
Put this interface “Out of Service” when an always-on connection attempt fails.
Normally, always-on interfaces do not go out of service unless they have connected at least
once. When enabled, this setting causes the router to put the interface out of service even if
the first connection attempt fails.
Attempt to re-connect after s seconds
The length of time, in seconds, the router should wait after an “always-on” PPP connection has
been terminated before trying to re-establish the link.
If an inhibited PPP interface is connected, attempt to re-connect after s seconds
This setting takes precedence over the previous parameter when another PPP instance that is
usually inhibited by this one is connected. Use this parameter to reduce the connection retry
rate when a lower priority PPP instance is connected.
Wait s seconds after power-up before activating this interface
The initial delay that the router will apply before activating the PPP instance after power-up.
After the initial power-up delay the normal always-on activation timers apply. If set to 0, no
delay is applied.
Control when this interface can connect using Time band n
Enables the time band function and allows selecting the desired time band instance. See
Configuring time bands for more information on time bands.
Keep this interface up for at least s seconds
The minimum period that the PPP interface should remain available. This means that even if
the link becomes inactive before this period expires, the connection remains open.