Digi TransPort WR11 - At&W: Write SREGS.DAT File

Using the command-line interface AT commands
Digi TransPort® Routers User Guide
162
at&w: Write SREGS.DAT file
The at&w command saves the current command and S registers settings (for the active port), to the
file SREGS.DAT. You can reload the settings in this file at any time using the atz command.
After the at&w command, you can specify a profile number, either 0 or 1, to store the settings in the
specified profile. For example, the following command stores the current settings as profile 1:
at &w1
If no profile number is specified, profile 0 is assumed.
at&w writes all S register values and the following command settings:
e, &c, &d, &k