Using the command-line interface Application commands
Digi TransPort® Routers User Guide
132
Application commands
The Digi TransPort router also supports numerous text-based application commands that are specific
to Digi International products, and do not require the AT prefix. Some of these are generic, such as
they are related to the general operation of the router; others are application- or protocol-specific.
Application commands are case-insensitive
Digi application commands (referred to as text commands or CLI commands throughout the
remainder of this guide), can be entered in upper or lower case.
One command per line
Unlike AT commands, only one command may be entered on a line. After each successful command,
the OK result code will be issued. An invalid command will cause the ERRORresult code to be issued.
Application command syntax
The general syntax for an application commands is:
<ent i t y> <i nst ance> <par am_name> <val ue>
where:
<ent i t y> is the name of the router feature being configured.
<i nst ance> is the instance number for the entity that you are configuring.
<par am_name> is the name of the parameter that you wish to configure.
<val ue> is the new value for the specified parameter.
For example, to set the window size to 5 for X.25 PAD instance 1, type:
pad 1 wi ndow 5
If there is only once instance of particular entity, type 0 for the instance number.
Use wildcards in commands
Command line
When viewing and not setting parameters, you can use wildcards in the field <param_name>. For
example, to view all PPP 1 parameters that start with r, enter:
ppp 1 r * ?
The output is:
ppp 1 r * ?
r _mr u: 1500
r _acf c: OFF
r _pf c: OFF
r _pap: ON
r _chap: ON
r _accm: 0xf f f f f f f f
To Next Page
Loading...
