Digi TransPort WR11 - Support for Virtual Routing and Forwarding in the Web and Command-Line Interfaces

Configuring IP routing and forwarding Configure Virtual Routing and Forwarding (VRF)
Digi TransPort® Routers User Guide
466
Step Command Purpose
2 Switch(config)# ip routing Enables IP routing.
3 Switch(config)# ip vrf vrf-name Names the VRF and enters
VRF configuration mode.
4 Switch(config-vrf)# rd route-distinguisher Creates a VRF table by
specifying a route
distinguisher. Enter either an
AS number and an arbitrary
number (xxx:y) or an IP
address and arbitrary number
(A.B.C.D.y).
5 Switch(config-vrf)# route-target {export|import|both}
route-target-ext-community
Creates a list of import,
export, or import and export
route target communities for
the specified VRF. Enter either
an AS number and an arbitrary
number (xxx:y) or an IP
address and arbitrary number
(A.B.C.D.y).
Note: This command is
effective only if BGP is running.
6 Switch(config-vrf)# import map
route-map
(Optional) Associates a route
map with the VRF.
7 Switch(config-vrf)# interface
interface-id
Enters interface configuration
mode and specifies the Layer 3
interface to associate with the
VRF. The interface can be a
routed port or SVI.
8 Switch(config-if)# ip vrf forwarding
vrf-name
Associates the VRF with the
Layer 3 interface.
9 Switch(config-if)# end Returns to privileged EXEC
mode.
10 Switch# show ip vrf [brief|detail|interfaces] [vrf-name]
(config-if)# ip vrf forwarding
vrf-name
Verifies the configuration.
Displays information about the
configured VRFs.
11 Name of the VRF export route map for exporting IP prefixes
from the VRF
Saves your entries in the
configuration file.
Support for Virtual Routing and Forwarding in the web and
command-line interfaces
TransPort routers support Virtual Routing and Forwarding on Ethernet, GRE, and PPP interfaces.
Configuration support for PPP interfaces is command-line only.