Configuring Virtual Private Networking (VPN) Configure Internet Protocol security (IPsec)
Digi TransPort® Routers User Guide
499
Close the IPsec tunnels after no response for n DPD requests
The maximum number of DPD requests that will be sent without receiving a response before
the IPsec tunnels are closed.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
dpd 0 inact Integer Mark the IPsec tunnel as suspect if there is no traffic
for n seconds
dpd 0 okint Integer Send a DPD request on a healthy link every n seconds
dpd 0 failint Integer Send a DPD request on a suspect link every n seconds
dpd 0 maxfail Integer Close the IPsec tunnels after no response for n DPD
requests
To Next Page
Loading...
