Configuring network interfaces Configure Ethernet interfaces
Digi TransPort® Routers User Guide
183
Port Isolate mode
If the router is running in Port Isolate mode, the following will be displayed, with an option to
switch to Hub mode.
Hub Mode (factory default)
If the router is running in Hub mode, the following is displayed, with an option to switch to Port
Isolate mode.
Ethernet Hub group
On routers with a built-in hub/switch, the Ethernet Hub group parameter for each port is
normally set to 0. This means that all ports belong to the same hub. If required, you can use the
To Next Page
Loading...
