Digi TransPort WR11 - Page 197

Configuring network interfaces Configure Ethernet interfaces
Digi TransPort® Routers User Guide
197
Reset probe failure count after n probe successes
The number of consecutive successful probes required before the current failure count is reset
to 0.
Use interface x,y over which to send probe
Overrides the routing code and forces the probe packets to be sent out of a specific interface.
Get the source IP address from interface x,y
Enables probe packets having the source IP address from a specific interface, rather than the
interface over which it is being transmitted.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
eth n vrrpid 0-255 VRRP Group ID
eth n vrrpprio 0-255 VRRP Priority
eth n vboostprio 0-255 Boost the priority by n for s
seconds after switching to the
MASTER state
eth n vboostsecs Integer Boost the priority by n for s
seconds after switching to the
MASTER state
eth n vprobemode off, TCP, ICMP Send p probe to IP address
a.b.c.d TCP port n
eth n vprobeip IP Address Send p probe to IP address
a.b.c.d TCP port n
eth n vprobeport 0-65535 Send p probe to IP address
a.b.c.d TCP port n
eth n vprobebackint 0-32767 every n seconds when in
Backup state
eth n vprobemastint 0-32767 every n seconds when in Master
state
eth n vprobeadj 0-255 Adjust priority n dir after x
probe failures
eth n vprobeadjup 0=down
1=up
Adjust priority n dir after x
probe failures
eth n vprobefailcnt 0-255 Adjust priority n dir after x
probe failures