Digi TransPort WR11 - Page 207

Configuring network interfaces Configure Ethernet interfaces
Digi TransPort® Routers User Guide
207
IP Address
The destination IP address. This parameter is optional. If configured, only packets destined for
this IP address have VLAN tagging applied.
Mask
The destination IP subnet mask. This parameter is optional. If configured, only packets
destined for this IP subnet mask have VLAN tagging applied.
Source IP Address
The source IP address. This parameter is optional. If configured, only packets from this IP
address have VLAN tagging applied.
Source Mask
The source IP subnet mask. This parameter is optional. If configured, only packets from this IP
subnet mask have VLAN tagging applied.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
eth n vlan on, off Enable VLAN support on Ethernet
interfaces
vlan n vlanid 0-4095 VLAN ID
vlan n ethctx Integer Ethernet Interface
vlan n ipaddr IP Address IP Address
vlan n mask IP Mask Mask
vlan n srcipaddr IP Address Source IP Address
vlan n srcmask IP Mask Source Mask