Digi TransPort WR11 - Page 217

Configuring network interfaces Configure Wi-Fi interfaces
Digi TransPort® Routers User Guide
217
Link this Wi-Fi client interface with Ethernet n
When the Wi-Fi interface is configured to be a client, it must be bridged to a particular Ethernet
interface.
This Wi-Fi rogue scanner will use Ethernet n
When the Wi-Fi interface is configured to be a rogue scanner, it uses the selected Ethernet
interface.
Hide SSID
When enabled, the SSID is not included in the beacon messages transmitted by the Wi-Fi
interface when in Access Point mode. This means that Wi-Fi clients cannot auto-detect the
Access Point.
Enable station isolation
When enabled, connected Wi-Fi clients cannot communicate with other Wi-Fi clients or Ethernet
hosts connected to this Access Point.
Click here to assign a timeband to this interface
You can optionally assign a time band to the Wi-Fi interface. Time bands determine periods of
time during which the router allows activating PPP or Wi-Fi interfaces or prevents them from
activating. The Configuration > Network > Timebands
page opens with a list of interfaces.Go to the Wi-Fi interface list and enable time bands as
desired. See Configure a time band for more information.
3. In the Security section, configure Wi-Fi security for the node:
If you are using multiple Wi-Fi interfaces at the same time, the interfaces must use the same
security settings, except for the pre-shared key (PSK). The only alternative is to use Wi-Fi with
no security.
Use the following security on this Wi-Fi interface
Selects the security on this Wi-Fi interface. The options are:
n None
n WEP
n WPA-Personal
n WPA2-Personal
n WPA-Enterprise
n WPA2-Enterprise
WEP Settings
The various WEP security settings for both Access Point and Client modes.
WEP Key size
The WEP key size to use.