Digi TransPort WR11 - Page 219

Configuring network interfaces Configure Wi-Fi interfaces
Digi TransPort® Routers User Guide
219
4. To connect the Wi-Fi node to an existing Wi-Fi Access Point, click Network Scanning and click
Perform Network Scan. The router scans the local airwaves for any Access Points that are
present, and lists the results in a table:
Click Connect to connect to one of the Access Points.
5. Click Apply.
Command line
Basic Wi-Fi node settings
Command Instance Parameter Values Equivalent web parameter
wifinode 0 enabled on, off Enable this Wi-Fi interface
wifinode 0 descr String Description
wifinode 0 ssid String up to 32
characters
SSID
wifinode 0 mode ap, client,
rogue
Mode
wifinode o bridge_inst 0-3 This Wi-Fi interface is a member of
Bridge instance n and therefore
bridged to the following interfaces
eth n bridge_inst 0-3 Interface
eth n wificli on, off Link this Wi-Fi client interface with
Ethernet n
eth n wificli_add Integer Link this Wi-Fi client interface with
Ethernet n
wifinode 0 broadcastssid on, off Hide SSID
wifinode 0 isolation on, off Enable station isolation
wifinode n roam_threshold RSSI value None; command-line only
wifinode n roam_timeout Seconds None; command-line only