Digi TransPort WR11 - Page 28

Hardware features TransPort WR11 hardware features
Digi TransPort® Routers User Guide
28
3. LEDs:
n SERVICE LED: Indicates the presence and level of cellular service running on the device.
Off: No cellular service
1 Blink: GPRS mode
2 Blinks: EDGE mode
3 Blinks: UMTS mode
4 Blinks: HSDPA mode
5 Blinks: HSUPA mode
6 Blinks: LTE mode
n SIGNAL LED: Indicates strength of cellular signal.
Off: Poor or No signal. Place the device in a location where it gets a better
signal.
Amber: Fair
Green: Good
n POWER LED:
Off: No power
Green: TransPort device is powered
4. SIM door: Encloses the SIM sockets. The SIM door must be opened to install the SIM cards. For
installation details, refer to the Quick Start Guide that came with your device.
5. Reset button: Resets the router to factory defaults. See Reset the router to factory defaults.
6. SIM sockets: SIM 1 and SIM 2 are for use with the SIMs. Insert SIM cards with the notch facing
the bottom-right corner of the device. If you are using one SIM card only, insert it in the SIM 1
slot.
7. Primary cellular antenna connector: This SMA female connector connects the device’s
primary cellular antenna.
8. Secondary cellular antenna connector: This SMA female connector connects the device’s
secondary cellular antenna.