Hardware features TransPort WR11 hardware features
Digi TransPort® Routers User Guide
32
Declaration of Conformity must be issued for each of these standards and kept on file as described in
the RE Directive (Radio Equipment Directive).
Furthermore, the manufacturer must maintain a copy of the Digi TransPort WR11 user manual
documentation and ensure the final product does not exceed the specified power ratings, antenna
specifications, and/or installation requirements as specified in the user manual. If any of these
specifications are exceeded in the final product, a submission must be made to a notified body for
compliance testing to all required standards.
OEM labeling requirements
The “CE” marking must be affixed to a visible location on the OEM product.
CE labeling requirements
The CE mark shall consist of the initials “CE” taking the following form:
n If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be respected.
n The CE marking must have a height of at least 5 mm except where this is not possible on
account of the nature of the apparatus.
n The CE marking must be affixed visibly, legibly, and indelibly.
Maximum power and frequency bands
Max power Frequencies
2 W Cellular 850 and 900 MHZ bands
1 W Cellular 850 and 900 MHZ bands
Innovation, Science, and Economic Development Canada (IC) certifications
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
To Next Page
Loading...
