Digi TransPort WR11 - Page 333

Configuring network interfaces Configure serial interfaces
Digi TransPort® Routers User Guide
333
Send Socket ID
When enabled, the text entered into the Socket ID field is transmitted to the remote host
when the socket connects.
Reopen Closed Socket
Enables an always-on mode. If the socket is closed for any reason, the router attempts to
reconnect to the remote host.
Socket ID
Used in conjunction with Send Socket ID. The text entered is transmitted when the socket
connects.You can use \r for CR and \n r NL. To specify hexadecimal, use \xhh where hh is the
hexadecimal code. For example \x04 defines binary character 04.
Send serial data only when the match string is present
Enables or disables the match string function.
Match String
When enabled, forwards serial data to remote hosts only when the Match String text is
present.
Strip match string before sending
When enabled, the text in the Match String field is removed before forwarding the data to the
remote host.
Remote host
Up to five remote hosts can be specified in these fields.
Host
Enter the hostname or IP address of the remote host in this field.
Port
Enter the TCP or UDP port number that the remote host is listening on.
Add
Click this button to add the remote host.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
multitx 0 enabled off, on Enable MultiTX
multitx 0 srcport off, on (default:
off)
Serial Port
multitx 0 prot1 off, on (default:
off)
protocol