Digi TransPort WR11 - Page 378

Configuring network interfaces Configure PPP and external modems
Digi TransPort® Routers User Guide
378
Stop data from being transmitted after n Kbytes/Mbytes/GBytes
The value in this text box specifies the total amount of data that may be transmitted by this
PPP instance before the link is blocked for further traffic, and the value in the drop-down list
specifies the units which are; KBytes, MBytes, GBytes.
Reset the data limit on the n day of the month
The day of the month on which the data limit is reset to 0.
When the link disconnects, indicate that the connection failed if no IP packets were
received
Reset this interface if n packets are transmitted and the connection has been up for at
least s seconds
The values in these text boxes control the circumstances under which the link can be reset. If
the number of packets text box has a value greater than 0, the router will reset the link if that
many IP packets have been transmitted but none have been received, and the link has been
active for at least the value specified in the second text box.
Reboot the router after n consecutive resets
If the value in this text box is non-zero, the router reboots if the PPP link has been reset the
specified number of times as a consequence of the value n packets (described above) being
exceeded.
Reboot the router after n consecutive connection failures
If the value in this text box is non-zero, the router will reboot if it fails to establish a connection
over this PPP instance after the specified number of consecutive attempts.
Use RADIUS for authentication when acting as a server
Use RADIUS instance
Allow this PPP interface to attempt to connect n times before allowing other PPP
interfaces inhibited by this interface to connect
The number of connection attempts this PPP instance is allowed to make before other PPP
instances that are inhibited by this instance may make connection attempts.
If this PPP interface gets disconnected, allow it to attempt to reconnect n times before
allowing other PPP interfaces inhibited by this interface to connect
On W-WAN routers, this setting specifies the number of times that a PPP instance which was
connected and is then disconnected, is allowed to attempt to reconnect before other PPP
instances that were inhibited by this PPP instance will be allowed to connect.