Configuring DNS Configure Dynamic DNS (DynDNS)
Digi TransPort® Routers User Guide
424
Supply the IP address in the update
When enabled (the default), causes the router to supply the IP address as part of the dynamic DNS
update. When unchecked, the IP address is not supplied and the DYNDNS server attempts to
determine the correct IP address by other means (IP source address in update packet). Use this mode
if the router is behind a NAT router only.
Only send update when this router is the VRRP master
When enabled, causes the router to not send DDNS updates unless at least one Ethernet interface is a
VRRP master.
Enable debug
When enabled, enables debug tracing of the dynamic DNS transactions.
Command line
Command Instance Parameter Values Equivalent web parameter
dyndns 0 updateint 0 -255 Update interval d days
dyndns 0 noip off, on Supply the IP address in the update
dyndns 0 ifvrrpmaster off, on Only send update when this router is
the VRRP master
dyndns 0 debug off, on Enable debug
To Next Page
Loading...
