Configuring IP routing and forwarding Configure default IP routes
Digi TransPort® Routers User Guide
443
Use metric n when the interface is not active
The routing metric to use when the interface is not active.
Use this route only if the source IP address of the packet matches
When enabled, the following two parameters are enabled:
IP address a.b.c.d
If necessary, use this parameter IP Address and the Mask parameter to further qualify the way in
which the router routes packets. If the values in this text box and the Mask parameter are set, the
source address of the packet being routed must match these parameters before the packet will be
routed through the specified interface.
To Next Page
Loading...
