Digi TransPort WR11 - Page 505

Configuring Virtual Private Networking (VPN) Configure Internet Protocol security (IPsec)
Digi TransPort® Routers User Guide
505
n Both removes IPSec SAs when their IKE SA is deleted, and deletes IKE SAs when their
IPSec SAs are removed.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
ike n retranint 0-255 Retransmit a frame if no response
after n seconds
ike n retran 0-9 Stop IKE negotiation after n
retransmissions
ike n inactto 0-255 Stop IKE negotiation if no packet
received for n seconds
ike n dpd on, off Enable Dead Peer Detection
ike n natt on, off Enable NAT-Traversal
ike n initialcontact on, off Send INITIAL-CONTACT
notifications
ike n keepph1 on, off Retain phase 1 SA after failed
phase 2 negotiation
ike n privrsakey Filename RSA private key file
ike n delmode 0=Normal
1=Remove IKE SA when
last IPsec SA removed
2=Remove IPsec SAs
when IKE SA remove
3=Both
SA Removal Mode
ike n openswan on, off None. This enables support for
Openswan IKE implementations.
IKE Responder command
ÉWeb
1. Go to Configuration > Network > Virtual Private Networking (VPN) > IPsec > IKE > IKE
Responder.
The IKE Responder page displays the various parameters for IKE 0 in Responder mode.