Digi TransPort WR11 - Page 530

Configuring Virtual Private Networking (VPN) Configure OpenVPN
Digi TransPort® Routers User Guide
530
Include in RIP advertisements
When enabled, the router includes this static route in RIP advertisements.
Automatically connect interface
If enabled, this OpenVPN instance will be considered as an Always On interface.
Server mode (listener)
Configures the OpenVPN instance to listen for inbound OpenVPN sockets.
Link socket port
The default port for OpenVPN is 1194. If you use a different or non-standard port number,
specify it here.
Link socket protocol
OpenVPN can use TCP or UDP as the transport protocol. Select the required protocol here.
TLS auth password / Confirm TLS auth password
Allows the OpenVPN instance to use an extra level of security by having a TLS password
configured.
Push IP address #1/#2/#3
When configured as an OpenVPN server, use these parameters to push subnets to the client
that need to be routed via the OpenVPN server. Used in conjunction with the Push Mask
parameter below.
Push mask #1/#2/#3
Use with the Push IP address parameter above to define subnets that should be routed via
the OpenVPN server.
Push DNS server address #1/#2
When configured as an OpenVPN server, use these parameters to push DNS server settings to
the OpenVPN client.
Pull interface IP address
When configured as an OpenVPN client, this option must be enabled for the router to obtain
and use the local IP address supplied from the OpenVPN server.
Pull routes
When configured as an OpenVPN client, this option must be enabled for the router to use
routes sent from the OpenVPN server.
Pull DNS server addresses
When configured as an OpenVPN client, this option must be enabled for the router to use DNS
servers sent from the OpenVPN server.