Digi TransPort WR11 - Page 587

Configuring advanced network settings Configure advanced network settings
Digi TransPort® Routers User Guide
587
address becomes unavailable, the router tries the backup IP address. If that IP address is
unavailable, the router tries its backup IP address, and so on.
For example, if the original IP address is 192.168.0.1 with a backup IP address of 192.168.0.2,
setting the IP address in the next row to 192.168.0.2 with a backup IP address of 192.168.0.3
causes the router to try all these IP addresses in succession.
Note The time that it takes for a connection to an IP address to fail is determined by the
Connect Timeout parameter Advanced Network Settings > Socket Settings section.
6. Click Apply.
Command line
Configure first group of advanced network settings
Command Instance Parameter Values Equivalent web parameter
cmd n sec_ip Valid IP
address
Secondary IP address a.b.c.d
sockopt n asymss 0-2147483648 When connected to a serial
interface using TCP Advertise an
MSS of n bytes
sockopt n asyrxwin 0-2147483648 Use a Rx Window size of n bytes
sockopt n sslver 0-3
0=Auto
1=TLSv1
2=SSLv2
Default SSL version for outgoing
connections
Configure socket settings
Command Instance Parameter Values Equivalent web parameter
sockopt n gp_ipent 0,PPP,ETH Default source IP address
interface x,y
sockopt n gp_ipadd Valid interface
number
Default source IP address
interface x,y
sockopt n sock_connto 0-2147483648 Connect Timeout s seconds
sockopt n sock_inact 0-2147483648 TCP socket inactivity timer s
seconds
sockopt n sock_keepact 0-2147483648 TCP socket keep-alive s
seconds