Digi TransPort WR11 - Page 641

Configuring legacy protocols Configure X.25 parameters
Digi TransPort® Routers User Guide
641
DTE cannot handle a continuous flow of data at high speed.
Option Description
0 Normal data delivery to DTE
1 Output to DTE discarded
9 Padding after CR
Slower terminal devices, such as printers, may require a delay after each Carriage Return before they
can continue to process data. This parameter controls the number of pad characters (NUL-ASCII 0)
that are sent after each CR to create such a delay.
Option Description
0 No padding characters after CR
1-255 Number of padding characters (NUL) sent after CR
10 Line folding
Controls the automatic generation of a [CR],[LF] sequence after a certain line width has been
reached.
Option Description
0 No line folding
1-255 Width of line before the PAD generates [CR],[LF]
11 Port speed
This is a read only parameter, set automatically by the PAD and accessed by the remote system.
Option Description
15 19,200 bps
14 9,600 bps
12 2,400 bps
3 2,400 bps
12 Flow control of PAD (by DTE)
Determines the flow control setting of the PAD by the DTE in the on-line data state.
Option Description
0 No flow control
1 XON/XOFF flow control
3 RTS/CTS flow control (not a standard X.3 parameter)