Configuring legacy protocols Configure X.25 parameters
Digi TransPort® Routers User Guide
653
Code Verbose message
83 A suspended call exists, but this call identity does not
84 Call identity in use
85 No call suspended
86 Call having the requested call identity has been cleared
88 Incompatible destination
90 Destination address missing or incomplete
91 Invalid transit network selection
95 Invalid message, unspecified
96 Mandatory information element is missing
97 Message type non-existent or not implemented
98 Message not compatible with call state or message type nonexistent or not implemented
99 Information element non-existent or not implemented
100 Invalid information element contents
101 Message not compatible with call state
102 Recovery on timer expired
111 Protocol error, unspecified
127 Interworking, unspecified
128 General level 2 call control failure (probable network failure)
CLR command: Clear an X.25 Call
The CLR command clears the current call and release the associated virtual channel for further calls.
On completion of call clear, the PAD> prompt is re-displayed. Several other situations can clear a call.
If one of these situations occurs, a message is issued to the PAD in the following format:
CLR <Reason> C: <n> - <t ext >
where:
n <Reason> is a 2/3 character clear down code
n <n> is the numeric equivalent of the clear down code
n <text> is a description of the reason for clear down
The clear down reason codes supported by the router are listed in the following table:
Reason Code Numeric Code Text
DTE 0 by remote device
To Next Page
Loading...
