Digi TransPort WR11 - Page 729

Configuring system settings Set power control options
Digi TransPort® Routers User Guide
729
Command line
Command Instance Parameter Values Equivalent web parameter
pwrctrl 0-3 cpuspeed 0-3
Available speed values vary by
model
0 = high speed (454 MHz)
1 = low speed (360 MHz)
2
3
CPU Speed
pwrctrl 0-3 leds on, off LEDs
pwrctrl 0-3 eth on, off Ethernet
pwrctrl 0-3 gprs on, off Mobile Module
pwrctrl 0-3 gps on, off GPS
pwrctrl 0-3 wifi on, off Wi-Fi
pwrctrl 0-3 dsl on, off DSL
pwrctrl 0-3 act_rq
The power control profile
number.
You can enter this command
immediately after setting the
parameters and is useful
when testing the
functionality. You must save
the profile by entering config
0 save.
None - Power control profile is
selected through command
line only.
pwrctrl none status Displays the current active
power control configuration
The Power Control display for
the currently selected power
control profile.
Example
To set setting a router's CPU to low-speed and all other power control parameters to off, enter:
pwr ct r l 1 cpuspeed 1
OK
pwr ct r l 1 l eds of f
OK
pwr ct r l 1 et h of f
OK
pwr ct r l 1 gpr s of f
OK
pwr ct r l 1 gps of f
OK
pwr ct r l 1 ?
Par amet er s ar e. .
cpuspeed: 1
l eds: OFF