Digi TransPort WR11 - Page 746

Configuring remote management Use SNMP for remote management
Digi TransPort® Routers User Guide
746
SNMPv3 settings
Username
The name of the SNMP user.
Authentication None, MD5, SHA1, SHA256
Select the authentication algorithm to apply to SNMP transactions.
Authentication Password
The authentication password for the user.
Confirm Authentication Password
The authentication password is not shown as clear text. The confirmation box allows a simple
check that the password has been entered correctly.
Encryption None, DES, AES
These three radio buttons select which encryption (privacy) algorithm should be applied to the
SNMP data.
Encryption Password
Enter the user’s password for controlling privacy of the SNMP transactions into this text box.
Confirm Encryption Password
The encryption password is not shown as clear text. The confirmation box allows a simple
check that the password was entered correctly.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
snmpuser n community public / private Community
snmpuser n name user_name Username
snmpuser n auth Off,MD5,SHA1 Authentication, None, MD5, SHA1
snmpuser n authPassword my_password Authentication Password
snmpuser n priv Off,DES,AES Encryption, None, DES, AES
snmpuser n privPassword my_password Encryption Password