Configuring security Configure user security settings
Digi TransPort® Routers User Guide
757
Remote Peer IP subnet mask
The remote subnet mask parameter. Use with the Remote Peer IP subnet parameter above
to fully qualify the network address for the user.
Public Key file
The name of the file containing the public key for that user. If the public key matches the client
supplied public key, the user is allowed access.
Default WEB page
Sets the default web interface page to open for the user.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
user 0 dun_en on, off Allow this user to log in over a PPP network
user 0 phonenum Number Use this number x when PPP dial-back is
required for this user
user 0 newpwd String
(up to 14
chars)
Alternate IKE Key
user 0 fieldip IP Address Remote Peer IP address
user 0 ipaddr IP Address Remote Peer IP subnet
user 0 mask IP Mask Remote Peer IP subnet mask
user 0 keyfile Filename Public Key file
user 0 defpage Web page
name
Default WEB page
To Next Page
Loading...
