Digi TransPort WR11 - Page 817

Configuring telemetry (GPS) Configure GPS parameters
Digi TransPort® Routers User Guide
817
Suffix the message with t
A text string that should follow the NMEA data, if desired.
IP Connection 2
Sends GPS messages to IP address a.b.c.d.
Port n
The required TCP/UDP port number to which the GPS data should be sent.
Every n interval(s)
How often the GPS data is transmitted to the specified host.
n A value of 1 causes collected GPS data to be transmitted each time a UTC and local
date/time data (ZDA) message is received from the GPS receiver module.
n A value of 2 causes every second message to be sent and so on.
For this feature to work over a TCP/IP connection, the ZDA message must be enabled.
Use TCP / UDP
The protocol to use for sending the messages.
Prefix the message with t
A text string that should precede the NMEA data, if desired.
Suffix the message with t
A text string that should follow the NMEA data, if desired.
3. Click Apply.
Command line
gps command
Command Instance Parameter Values
Equivalent web
parameter
gps 0 asy_add The ASY port to which the GPS
receiver is connected
n/a
gps 0 gpson On, Off Enable local monitoring
gps 0 init_str Valid command for GPS receiver GPS Module Initialization
string
gps 0 gga_on 0, 1
0=Off
1=On
Fix data (GGA)