Hardware features TransPort WR44 / WR44 R hardware features
Digi TransPort® Routers User Guide
88
Declaration of Conformity must be issued for each of these standards and kept on file as described in
the RE Directive (Radio Equipment Directive).
Furthermore, the manufacturer must maintain a copy of the Digi TransPort WR44 user manual
documentation and ensure the final product does not exceed the specified power ratings, antenna
specifications, and/or installation requirements as specified in the user manual. If any of these
specifications are exceeded in the final product, a submission must be made to a notified body for
compliance testing to all required standards.
OEM labeling requirements
The “CE” marking must be affixed to a visible location on the OEM product.
CE labeling requirements
The CE mark shall consist of the initials “CE” taking the following form:
n If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be respected.
n The CE marking must have a height of at least 5 mm except where this is not possible on
account of the nature of the apparatus.
n The CE marking must be affixed visibly, legibly, and indelibly.
Maximum power and frequency bands
Max power Frequencies
2 W Cellular 850 and 900 MHz bands
1 W Cellular 1800 and 1900 MHz bands
200 mW 13 overlapping channels, each 22 or 40 MHz wide and spaced at 5
MHz. Centered at 2.412 to 2.472 MHz.
251.19 mW 165 overlapping channels, each 22 or 40 or 80 MHz wide and spaced
at 5 MHz. Centered at 5180 to 5825 MHz.
To Next Page
Loading...
