Hardware features TransPort WR44 RR hardware features
Digi TransPort® Routers User Guide
98
Directive). A Declaration of Conformity must be issued for each of these standards and kept on file as
described in the RE Directive (Radio Equipment Directive).
Furthermore, the manufacturer must maintain a copy of the Digi TransPort WR44 RR user manual
documentation and ensure the final product does not exceed the specified power ratings, antenna
specifications, and/or installation requirements as specified in the user manual. If any of these
specifications are exceeded in the final product, a submission must be made to a notified body for
compliance testing to all required standards.
OEM labeling requirements
The “CE” marking must be affixed to a visible location on the OEM product.
CE labeling requirements
The CE mark shall consist of the initials “CE” taking the following form:
n If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be respected.
n The CE marking must have a height of at least 5 mm except where this is not possible on
account of the nature of the apparatus.
n The CE marking must be affixed visibly, legibly, and indelibly.
Maximum power and frequency bands
Max power Frequencies
2 W Cellular 850 and 900 MHz bands
1 W Cellular 1800 and 1900 MHz bands
200 mW 13 overlapping channels each 22 or 40 MHz wide and spaced at 5
MHz. Centered at 2.412 to 2.472 MHz
251.19 mW 165 overlapping channels, each 22 or 40 or 80 MHz wide and spaced
at 5 MHz. Centered at 5180 to 5825 MHz.
To Next Page
Loading...
