Digi TransPort WR31 - Page 306

Configure network interfaces Configure Advanced interfaces settings: External modems and PPP
Digi TransPort WR Routers User Guide 306
ppp n secDNS Valid IP address Secondary DNS server
ppp n DNSport Valid IP address
Default 53
DNS Port
ppp n IPmin Valid IP address
Default
10.10.10.10
Assign remote IP addresses from a.b.c.d to
a.b.c.d
ppp n IPrange 0-255
Default 5
Assign remote IP addresses from a.b.c.d to
a.b.c.d Note that these are not directly
equivalent. This address is obtained by adding
the range value to the minimum.
ppp n transDNS Valid IP address Primary DNS server
ppp n sectransDNS Valid IP address Secondary DNS server
ppp n cingnb up to 25 digits Only allow numbers ending with n
ppp n msn up to 9 digits with ISDN MSN ending with n
ppp n sub up to 17 digits with ISDN sub-address ending with n
cli
ppp n maxup 0-2147483648 Close the PPP connection after s seconds
ppp n maxuptime 0-2147483647 if it has been up for m minutes in a day
ppp n timeout Default 300s (5
minutes)
if it has been idle for h, m, s
ppp n timeout2 0-2147483648 Alternative idle timer for static routes s seconds
ppp n rxtimeout 0-2147483648 if the link has not received any packets for s
seconds
ppp n maxneg 0-2147483648 if the negotiation is not complete in s seconds
ppp n do_nat 0, 1
0=Off
1=On
Enable NAT on this interface
ppp n natip Valid IP address
a.b.c.d
NAT Source IP address a.b.c.d
ppp n ipsec 0, 1
0=Off
1=On
Enable IPsec on this interface
ppp n Keep Security Associations (SAs) when this PPP
interface is disconnected
Entity Instance Parameter Values Equivalent web parameter