Digi TransPort WR31 - Page 570

Configure legacy protocols Configure X.25 parameters
Digi TransPort WR Routers User Guide 570
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
pad n l2iface lapb, lapd, TCP, SSL Use PAD over interface
pad n l2nb 0-255 (instance of LAPB or
LAPD)
Use PAD over interface
pad n ip_stream 0=off (for XoT), 1=TCP,
2=UDP
Use PAD over interface
pad n defpak 16,32,64,128,256,512 or
1024
Default X.25 packet size
pad n ansnua text (valid NUA) Answer incoming calls from NUA
pad n anscug text (valid CUG) Only answer calls with CUG
pad n amacro text Use X.25 Call Macro macroname to an
ATD command
pad n cingnua text (valid NUA) Use NUA
pad n lcn 1-4095 LCN
pad n lcnup 1=up, 0=down LCN Direction
pad n nuaimode 0=NUI and NUA, 1=NUA
only, 2=NUI only
NUI/NUA selection
pad n dorest 1=enabled, 0=disabled Enable X.25 Restart Packets
pad n restdel 0 -60000 (ms) Restart delay
pad n IPaddr text Remote IP address
pad n buipaddr text Remote IP Address when using the
backup interface
pad n ip_port 0-65535 IP Stream port
pad n iphdr 0=Off
1=On
2=8583 Ascii 4 byte
IP length header
pad n prompt text PAD prompt
pad n padmode 0=Normal
1=Prompt Always On
PAD mode
pad n profile 1-4, 50, 51,90,91 Use PAD Profile
pad n strip_tspaces 1=enabled
0=disabled
Strip Trailing Spaces