dSPACE DS1103 - Master PPC UART RS232 Connector (CP40)

Because the pin numbering used for Sub-D connectors is not
standardized, the following figure shows the numbering scheme used
(front view).
Do not rely on the numbers written on Sub-D
connectors.
Pinout
CAN Connector
(CP38)
Pin Signal Pin Signal
5
1
6
9
5 GND
4 Not used 9 Not used
3 GND 8 Not used
2 CANL 7 CANH
1 Not used 6 GND
The CAN bus lines (CANH, CANL) are not terminated with
a resistor on the DS1103.
Master PPC UART RS232 Connector (CP40)
The master PPC UART RS232 connector (CP40) is a 9-pin, male Sub-D
connector located on the front of the connector panel. The pinout
has been adopted from the 9-pin, RS232 connector of a PC.
The master PPC of the DS1103 supports one serial
interface. In RS232 mode the signals are available from the
master PPC UART RS232 connector (CP40). In RS422 mode
the signals are available from the master PPC UART RS422
connector (CP42). CP40 and CP42 are mutually exclusive
and cannot be used at the same time.
Objective
Because the pin numbering used for Sub-D connectors is not
standardized, the following figure shows the numbering scheme used
(front view).
Do not rely on the numbers written on Sub-D
connectors.
Pinout
s
CP1103/CLP1103 Components
t
DS1103 Hardware Installation and Configuration November 2014
135
t