If any problem comes up when you set up a peer-to-peer
connection, see Problems with Peer
‑
To
‑
Peer Connection
on page 216.
Solving problems
Integrating the Expansion Box into a Network
The following instructions show how to integrate an expansion box
into an existing network step‑by‑step:
1. A peer-to-peer connection is needed temporarily to change the IP
address of the expansion box. Refer to How to Set Up a Peer-to-
Peer Connection on page 85.
2. The IP address of the expansion box must be changed to comply
with the IP addresses used in the network. Refer to How to
Change the IP Address of the Expansion Box on page 88.
3. After you have changed the IP address of the expansion box, you
can restore the previous IP address of the host PC. Refer to How to
Restore the TCP/IP Configuration of the PC on page 89.
4. Finish the work with How to Connect the Expansion Box to the
Network and Test the Connection on page 90.
Setup procedure
Information in this section
How to Change the IP Address of the Expansion Box 88
How to Restore the TCP/IP Configuration of the PC 89
How to Connect the Expansion Box to the Network
and Test the Connection
90
Information in other sections
How to Set Up a Peer-to-Peer Connection
After setting up the TCP/IP protocol, you can set up the peer-to-peer
connection.
85
Where to go from here
s
Setting Up The Ethernet Connection
t
DS1103 Hardware Installation and Configuration November 2014
87
t
To Next Page
Loading...
Need help?
General
