You can use this bracket to install the DS819 in host PCs which
support only low-profile cards. Remove the standard bracket and
mount the optional low-profile bracket on the link board.
dSPACE does not guarantee that the bracket fits to all low-
profile PCs which are available on the market.
DS819 Data Sheet
The following table provides the technical characteristics of the
DS819 Link Board (PC):
Technical data
Parameter Specification
Host interface n PCI Express x1 interface
n PCI Express slot (x1 ... x32)
Required software dSPACE Release 5.2 or later
Supported link interfaces DS814, DS830, MicroAutoBox
Physical connection n Crossed‑over patch cable: twisted pair (CAT5 STP)
n Fiber‑optic cable: multimode (62.5/125 μm)
Cable length per connection n Max. 10 m (crossed‑over patch cable)
n Max. 100 m (fiber‑optic cable)
Protocol High‑speed serial link (proprietary)
Max. transfer rate 100 MBit/s
1)
Power supply From PC:
n +3.3 V ±5%, 0.5 A
n +12 V ±5%, 0.2 A
Physical size 120 x 75 x 18 mm (4.7 x 3.0 x 0.7 in.)
Ambient temperature 0 … 70 ºC (32 … 158 ºF)
1)
The transfer rate describes the capabilities of the hardware components and circuits of dSPACE products. Depending on the
software complexity the attainable overall performance can deviate significantly from the hardware specification.
s
Accessories
t
238
s
DS1103 Hardware Installation and Configuration November 2014
To Next Page
Loading...
